Audi A4: Fluids in the A/C system
Refrigerant in the A/C system
The sticker in the motor compartment provides information about the type and amount of refrigerant used in the vehicle's A/C system. The sticker is located in the front section of the motor compartment or at the front or back of the hood.
.png)
Warning: the A/C system must only
be serviced by qualified technicians.
.png)
Refrigerant type
.png)
Lubricant type
.png)
Refer to the service information
(only available for authorized Audi
dealers or authorized Audi Service
Facilities)
.png)
The A/C system must only be
serviced by qualified technicians.
.png)
Flammable refrigerant
.png)
Make sure all components are
disposed
of correctly and never install components in the vehicle that have
been removed from old vehicles or
taken from recycling.
Lubricant in the A/C system
The sticker in the motor compartment provides information about the type and amount of refrigerant oil used in the vehicle's A/C system. For the refrigerant oil quantity, refer to the Technical Data.
WARNING
To ensure secure and safe operation, the A/C system must only be serviced by qualified technicians and certified technicians (SAE standard J2845).
Tips
- Never repair the A/C system evaporator with components from old vehicles or from recycling.
- New replacement evaporators for portable A/C systems must be certified and labeled as such, so that they comply with the SAE standard J2842 HFO-1234yf and R744.
READ NEXT:
Starting the vehicle
Convenience key
Applies to: vehicles with convenience key
Fig. 94 Center console: starting the engine
Requirement: the key must be in the vehicle.
Starting the engine
Press and hold the brake pedal
When driving
Starting to drive, stopping, and parking
Starting from a stop
Press and hold the brake pedal.
Start the engine.
Select "D" or "R".
Release the parking brake.
Release the brake pedal. The vehicle
SEE MORE:
Driver Front Airbag Crash Sensor -G283-, Removing and Installing
Note
The Passenger Side Front Airbag Crash Sensor -G284- is removed
and installed the same way.
Removing
WARNING
Risk of injury due to involuntary deployment.
Pay attention to the safety precautions when working
with pyrotechnic components. Refer to
→ Chapter "Safety Precau
Voltage Regulator, Valeo Generator from 2001, Removing and Installing
Removing
- Remove the generator. Refer to
→ Electrical Equipment; Rep. Gr.27; Generator; Generator,
Removing and Installing.
- Press the cover on the rear side of the generator off of the
threaded pins -arrows-.
- Remove the bolts -1- and the
double bolt -2-.
-&n
