General information
WARNING
If you leave the vehicle, switch the ignition
off and take the key with you. This applies
particularly when children remain in the vehicle.
Otherwise, children could s
SEE MORE:
Outer CV Joint, Removing
- Clamp the drive axle in a vise with protective covers.
- Open both clamps and remove the CV boot from the outer
joint.
- Drive out the CV joint from the drive axle with a copper or
brass mandrel -A- on the inner
ring.
- Remove joint and CV boot.
Out
Overview - Stabilizer Bar
1 - Bolt
25 Nm + 90º
Replace after removing
Tighten in the curb weight position. Refer to
→ Chapter "Wheel Bearing in Curb Weight Position, Lifting Vehicles with
Coil Spring".
Tighten alternating in stages
2 - Clamp
3 - Stabili