Audi A4: General, Technical data
- Safety Precautions
- Additional Safety Precautions for Airbag Control Module
- Restraint System Pyrotechnic, Electric and Mechanical Components, Replacing After a Collision
- Seat Belts, Checking
- Seat Belt Latch, Function Test
READ NEXT:
Safety Precautions
Safety Precautions when Working on Vehicles with Start/Stop System
There is a risk of injury due to the engine starting
unexpectedly.
The engine can start unexpectedly on vehicles with an activated
Additional Safety Precautions for Airbag Control Module
WARNING
After every removal and installation of the Airbag
Control Module -J234-, the "inertial sensor basic
setting" must be performed.
If the Airbag Control Module -J234- is replaced w
Restraint System Pyrotechnic, Electric and Mechanical Components,
Replacing After a Collision
Special tools and workshop equipment required
Vehicle Diagnostic Tester
The airbag control module must be replaced
If the display "Control module faulty" appears after checking
the DTC memory
A
SEE MORE:
Electric Coolant Pump, Removing and Installing
Coolant Recirculation Pump -V50-, Removing and Installing
Special tools and workshop equipment required
Hose Clamps - Up To 25mm -3094-
Hose Clip Pliers -VAS6340-
Removing
- Remove the engine cover. Refer to
→ Servicing - 4-Cylinder 2.0L 4V TFSI Engine; Rep. Gr.10; Engine
Center Console Rear Trim, Removing and Installing
Special tools and workshop equipment required
Wedge Set -T10383-
Wedge Set - Wedge 1 -T10383/1-
Removing
- Move the front seats all the way forward.
- Using either the -T10383/1- or by hand, unclip the trim
-1- from the center console in the
direction of -arrows-.
- Remove the tr
© 2019-2026 Copyright www.audia4b9.com
