Safety Precautions when Working on Vehicles with Start/Stop System
There is a risk of injury due to the engine starting
unexpectedly.
The engine can start unexpectedly on vehicles with an activated
WARNING
After every removal and installation of the Airbag
Control Module -J234-, the "inertial sensor basic
setting" must be performed.
If the Airbag Control Module -J234- is replaced w
Outer Rear Three-Point Seat Belt, Removing and Installing, Sedan
Caution
This procedure contains mandatory replaceable parts.
Refer to component overview and parts catalog prior to
starting procedure.
Mandatory Replacement Parts
Bolt - Automatic Belt Retractor (If parts of the seat belt
Special tools and workshop equipment required
Vehicle Diagnostic Tester
Note
If the connection between the steering gear and the steering
wheel is disconnected, the end position of the steering gear
must be readapted.
Procedure
- Connect the Vehicle Diagnostic Tester.
- Switch