Audi A4: Crankshaft, Cylinder Block
Audi A4 (B9) 2016-2026 Service Manual / Engine / 4-Cylinder Direct Injection 2.0L 4V TFSI Engine (EA 888
Generation III BZ) / Crankshaft, Cylinder Block
READ NEXT:
Cylinder Block, Belt Pulley Side
Overview - Cylinder Block, Belt Pulley Side
All components are described under:
→ Servicing - 4-Cylinder 2.0L 4V TFSI Engine; Rep. Gr.13; Cylinder Block Belt
Pulley Side; Overview -
Balance Shaft
Overview - Balance Shaft
1 - Cylinder Block
2 - Bolt
Tightening specifications. Refer to
→ Servicing - 4-Cylinder 2.0L 4V TFSI Engine; Rep. Gr.13; Balance Shaf
Cylinder Head, Valvetrain
Timing Chain Cover
Overview - Timing Chain Cover
All procedures and components are described under:
→ Servicing - 4-Cylinder 2.0L 4V TFSI Engine; Rep. Gr.15; Timing Chain Cover.
Cams
SEE MORE:
Hinges, Removing and Installing
Hinges, Removing and Installing, Sedan
Removing
- Remove the rear lid. Refer to
→ Chapter "Rear Lid, Removing and Installing, Sedan".
- Remove the luggage compartment side trim panel. Refer to
→ Body Interior; Rep. Gr.70; Luggage Compartment Trim Panels;
Luggage C
Overview - Drive Axle
1 - Clamp
Replace after removing
Tensioning. Refer to
→ Chapter "Clamp on Triple Roller Joint and Outer Joint, Tensioning".
2 - CV Boot
If the drive axle has a peened triple roller joint, then the triple
roller joint has an adapter installed
The CV boot must fit
© 2019-2026 Copyright www.audia4b9.com
