Audi A4: General information
WARNING
Follow the steps given above. This is for your
protection and the for the safety of others on
the road.
Equipment
Vehicle tool kit, tire mobility kit,
and vehicle jack
Applies to: vehicles with the vehicle tool kit, tire mobility kit,
and vehicle jack
Fig. 168 Luggage compartment: cargo area floor
The vehicle tool kit, vehicle jack, tire mobility kit,
and compressor are stored in the luggage compartment
under the cargo floor.
- Applies to: sedan: To open the front compartment,
lift the cargo floor by the strap (1).
- Applies to: allroad: To open the front compartment,
pull the cargo floor by the plastic handle
(2) slightly toward the rear. Lift the cargo floor
over the front compartment.
- To open the rear compartment, lift the cargo
floor by the plastic handle (2).
- Applies to: sedan: Engage the plastic handle (2)
in the luggage compartment seal.
- To remove the cargo floor completely, pull it
toward the rear using the plastic handle (2).
- Applies to: vehicles with spare tire: Turn the
handle counter-clockwise and remove the spare
tire.
- Applies to: sedan: Unhook the cargo floor again
before closing the luggage compartment lid.
Depending on vehicle equipment, the vehicle tool
kit, tire mobility kit, and compressor may be located
under another cover that is secured with a
handwheel.
Applies to: vehicles with vehicle jack in the storage
bag: The bag with the vehicle jack is secured
to the tie-downs in the luggage compartment
and must be secured to the tie-downs again after
using it.
WARNING
Applies to: vehicles with vehicle jack in the storage bag
A vehicle jack that is unsecured, incorrectly secured,
or not secured in the luggage compartment
may slide out of place when braking,
turning, or in an accident, which increases the
risk of injuries to vehicle passengers. To reduce
the risk of an accident, never transport
the vehicle jack without securing it.
Tips
- In some vehicles, the rear compartment
may not open.
- The vehicle jack in your vehicle is maintenance-
free.
READ NEXT:
Preparation
Applies to: vehicles with tire mobility kit
Read and follow the important safety precautions.
Set the parking brake.
Select the "P" selector lever position.
Check if a repair with the
Preparation
You must complete the preparation before
changing a tire.
Read and follow the important safety precautions.
Set the parking brake.
Select the "P" selector lever position.
When towing
Applies to: vehicles with vehicle jack
Fig. 174 Sill panels: markings
Fig. 175 Sill: positioning the vehicle jack
Place the vehicle jack from the vehicle tool kit
on a firm surface. Use a flat, s
SEE MORE:
Applies to: vehicles with telephone
Depending on your mobile device and the type of
connection, the following options may be available
during a call:
End call
Mute
Sending a tone sequence
Press Numbers. You can enter tone sequences
(DTMF) and send them to the other party on the
call.
Hold
Puts t
Special tools and workshop equipment required
Analog/Digital Multimeter -FLU83III-
Puller - Bevel Gear -T10474-
Torque Wrench 1332 40-200Nm -VAG1332-
Inner Hex Socket 8 mm or TORX T50
Battery Charger -VAS5095A-
Battery Tester with Printer -VAS5097A-
Battery Charger -VAS5900-