Audi A4: Self-Leveling Suspension

 Upper Control Arm, Removing and Installing

Special tools and workshop equipment required Vehicle Diagnostic Tester Torque Wrench 1331 5-50Nm -VAG1331- Torque Wrench 1331 Insert - Ring Wrench - 16mm -VAG1331/12-, not illustrated Torque Wrench 1332 40-200Nm -VAG1332- Engine and Gearbox Jack -VAS6931- Engine/Gearbox Jack Adapter - Wheel

 Overview - Drive Axle

1 - Clamp Replace after removing Tensioning. Refer to → Chapter "Clamp on Triple Roller Joint and Outer Joint, Tensioning". 2 - CV Boot If the drive axle has a peened triple roller joint, then the triple roller joint has an adapter installed The CV boot must fit