Audi A4: Chassis
Audi A4 (B9) 2016-2026 Service Manual / Chassis
- General, Technical data
- Front Suspension
- Subframe
- Suspension Strut and Upper Control Arm
- Lower Control Arm and Ball Joint
- Wheel Bearing
- Drive Axle
- Special Tools
- Rear Suspension
- Subframe
- Stabilizer Bar
- Control Arm, Tie Rod
- Suspension Strut, Shock Absorber, Spring
- Wheel Bearing and Trailing Arm
- Drive Axle
- Special Tools
- Self-Leveling Suspension
- Wheels, Tires, Wheel Alignment
- Steering
READ NEXT:
General Information
Chassis
Steering
Tire Types
For general information on wheel/tire combinations, winter tires, snow
chains, and recommended tire manufacturers, refer to
→Wheel and Tire Guide; Rep. Gr.44
Dri
Safety Precautions
Safety Precautions when Working on Vehicles with Start/Stop System
There is a risk of injury due to the engine starting
unexpectedly.
The engine can start unexpectedly on vehicles with an
activated
SEE MORE:
Charging the 12 volt vehicle battery
Fig. 162 Engine compartment: connectors for a charger or
jump start cables
Observe the safety precautions > General
information, in Battery general information.
Requirement: only use chargers with a maximum
charging current of 14.8 volts. The battery cables
remain connected.
The charging cable c
Input Shaft Double Shaft Seal, Replacing
Special tools and workshop equipment required
Puller - Crankshaft/Power Steering Seal -T20143-
Thrust Piece -T40300-
Clutch, engaging bearing and slave cylinder removed. Refer
to
→ Chapter "Dual Clutch, Removing and Installing".
- With the Puller - Crankshaft/Power Steering Seal
© 2019-2026 Copyright www.audia4b9.com
