Audi A4: Control Arm, Tie Rod
- Overview - Transverse Link
- Upper Transverse Link, Removing and Installing
- Lower Transverse Link, Removing and Installing
- Tie Rod, Removing and Installing
READ NEXT:
Overview - Transverse Link
Upper Transverse Link
1 - Wheel Bearing Housing
2 - Bolt
70 Nm + 180º
Replace after removing
3 - Front Upper Transverse Link
Removing and installing. Refer to
â†
Upper Transverse Link, Removing and Installing
Front Upper Transverse Link, Removing and Installing
Special tools and workshop equipment required
Torque Wrench 1332 40-200Nm -VAG1332-
Caution
This procedure contains mandatory replaceab
Lower Transverse Link, Removing and Installing
Rear Lower Transverse Link, Removing and Installing
Special tools and workshop equipment required
Torque Wrench 1332 40-200Nm -VAG1332-
Engine and Gearbox Jack -VAS6931-
Engine/Gearbox Jack Adapte
SEE MORE:
Charging the 12 volt vehicle battery
Fig. 162 Engine compartment: connectors for a charger or
jump start cables
Observe the safety precautions > General
information, in Battery general information.
Requirement: only use chargers with a maximum
charging current of 14.8 volts. The battery cables
remain connected.
The charging cable c
Component Location Overview - Navigation System
1 - Bracket
2 - Bolt
3 Nm
Quantity: 2
3 - Information Electronics Control Module 1 -J794-
Connector assignment. Refer to
→ Wiring diagrams, Troubleshooting & Component locations.
Removing and installing. Refer to
→ Chapter "Information E
© 2019-2026 Copyright www.audia4b9.com
