Audi A4: Rear Suspension
Audi A4 (B9) 2016-2026 Service Manual / Chassis / Rear Suspension
- Subframe
- Stabilizer Bar
- Control Arm, Tie Rod
- Suspension Strut, Shock Absorber, Spring
- Wheel Bearing and Trailing Arm
- Drive Axle
- Special Tools
READ NEXT:
Overview - Subframe
Overview - Subframe, FWD
Caution
There is a risk of damaging the threads on the subframe
threaded connection to the body.
The subframe bolts on the body must not be loosened or
tightened
Subframe, Securing
Special tools and workshop equipment required
Torque Wrench 1331 5-50Nm -VAG1331-
Torque Wrench 1332 40-200Nm -VAG1332-
Engine and Gearbox Jack -VAS6931-
Gearbox Support -T40173-
Locating Pins -
SEE MORE:
Glass Panel, Adjusting
Glass Panel, Adjusting, Sedan
Adjustment Dimensions
1 -
Front Glass Panel
Dimension -a- = 0 - 1 mm
Dimension -b- = 0 + 1 mm
Dimension -c- = 0 mm (flush)
2 -
Roof
Height Adjustment
To achieve the best possible exterior optical characteristics,
make sure that the adjustment
Receiver/Dryer or Accumulator and Restrictor, Replacing after Cleaning
Refrigerant Circuit
Note
Cleaning the refrigerant circuit means flushing it with
refrigerant R134a. Refer to
→ Chapter "Refrigerant Circuit, Cleaning (Flushing), with
Refrigerant R134a" or blowing through with compressed
air and nitrogen. Refer to
→ Chapter "Refrigerant Circuit, Flushing with
© 2019-2026 Copyright www.audia4b9.com
