Audi A4: Suspension Strut, Shock Absorber, Spring
Audi A4 (B9) 2016-2025 Service Manual / Chassis / Rear Suspension / Suspension Strut, Shock Absorber, Spring
- Overview - Suspension Strut, Shock Absorber, Spring
- Shock Absorber, Removing and Installing
- Spring, Removing and Installing
READ NEXT:
Overview - Suspension Strut, Shock Absorber, Spring
Overview - Spring
1 - Rear Lower Transverse Link
Removing and installing. Refer to
→ Chapter "Rear Lower Transverse Link, Removing and Installing".
2 - Coil Spring
Re
Shock Absorber, Removing and Installing
Special tools and workshop equipment required
Torque Wrench 1331 5-50Nm -VAG1331-
Torque Wrench 1332 40-200Nm -VAG1332-
Engine and Gearbox Jack -VAS6931-
Engine/Gearbox Jack Adapter - Wheel Hub S
Spring, Removing and Installing
Special tools and workshop equipment required
Pneumatic/Hydraulic Foot Pump -VAS6179-
Spring Tensioning System -VAS6274-
Spring Tensioning System - Spindle -VAS6274/3-
Spring Tensioning System -
SEE MORE:
Coolant temperature display
Applies to: vehicles with a coolant temperature indicator
The coolant temperature display (9) only functions when the ignition is
switched on.
To reduce the risk of engine damage, please observe
the following notes about the temperature
ranges.
Cold range
If only the LEDs at the bottom of the gaug
Windshield Antenna Suppression Filter -C18-, Removing and Installing
Windshield Antenna Suppression Filter -C18-, Removing and Installing,
Sedan
The Windshield Antenna Suppression Filter -C18- is located
behind the left D-pillar trim panel at the center of the
D-pillar.
Removing
- Turn off the ignition and all electrical equipment and
remove the ignition key
© 2019-2025 Copyright www.audia4b9.com
