Audi A4: Wheel Bearing and Trailing Arm
- Overview - Wheel Bearing
- Wheel Bearing Housing, Removing and Installing
- Wheel Bearing Unit, Removing and Installing
- Wheel Bearing Unit, Servicing
READ NEXT:
Overview - Wheel Bearing
Overview - Wheel Bearing, FWD
1 - Wheel Bearing Unit
Removing and installing. Refer to
→ Chapter "Wheel Bearing Unit, Removing and Installing, FWD".
Handling the wheel bearing. R
Wheel Bearing Housing, Removing and Installing
Special tools and workshop equipment required
Torque Wrench 1332 40-200Nm -VAG1332-
Engine and Gearbox Jack -VAS6931-
Engine/Gearbox Jack Adapter - Wheel Hub Support -T10149-
Caution
Thi
Wheel Bearing Unit, Removing and Installing
Wheel Bearing Unit, Removing and Installing, FWD
Special tools and workshop equipment required
Puller - Grease Cap -VW637/2-
Camshaft Installer Kit - Sleeve -3241/4- from the Seal
Installer - Cams
SEE MORE:
Locking Mechanism Trim, Removing and Installing
Special tools and workshop equipment required
Trim Removal Wedge -3409-
Removing
- Unlock the rear seat backrest.
- Make sure the button -2-
(indicator) is in the "up" position.
- Push the tabs in the direction of -arrows-
on both sides of the trim using a -3409-.
- Remove t
Inner CV Joint, Checking
It is necessary to disassemble the joint whenever replacing
the grease or if the ball surfaces show wear or damage.
Disassembling
Note
Ball hub and joint are paired and should be identified
before removal. Do not interchange ball race allocation.
- Tilt the ball hub and ball cage.
-&n
© 2019-2026 Copyright www.audia4b9.com
