Audi A4: Drive Axle
- Overview - Drive Axle
- Drive Axle, Removing and Installing
- Drive Axle, Disassembling and Assembling
- Inner CV Joint, Checking
READ NEXT:
Overview - Drive Axle
1 - Cap
Carefully drive off using a drift
Replace if damaged
Adhesive surface must be free of oil and grease
Coat the sealing surface with Sealant -D 454 300 A2- before installing on
Drive Axle, Removing and Installing
Caution
This procedure contains mandatory replaceable parts.
Refer to component overview and parts catalog prior to
starting procedure.
Mandatory Replacement Parts
Bolt - Outer CV Joint t
Drive Axle, Disassembling and Assembling
Drive Axle, Disassembling and Assembling, Outer CV Joint
Special tools and workshop equipment required
Locking ring pliers, commercially available
Sealant -D454 300 A2-. Refer to the Parts Catalog.
SEE MORE:
Subframe, Lowering
Special tools and workshop equipment required
Torque Wrench 1331 5-50Nm -VAG1331-
Torque Wrench 1332 40-200Nm -VAG1332-
Tensioning Straps -T10038-
Engine and Gearbox Jack -VAS6931-
Locating Pins -T40327-
Procedure
Note
During installation, all cable ties must be installed at the
same
General, Technical data
Repair Information
General Repair Information
Using the Repair Manual
Refer to the "7-Speed DSG
Transmission 0CK" repair manual for all special procedures with
the transmission installed, depending on the model. The
servicing repair manual either does not describe them or
describes them only par
© 2019-2026 Copyright www.audia4b9.com
