Audi A4: Subframe
- Overview - Subframe
- Subframe, Securing
- Subframe, Lowering
- Subframe with Steering Gear, Removing and Installing
- Subframe Crossbrace, Removing and Installing
- Stabilizer Bar, Removing and Installing
READ NEXT:
Overview - Subframe
Subframe
Caution
There is a risk of damaging the threads on the subframe
threaded connection to the body.
The subframe bolts on the body must not be loosened or
tightened with an impact w
Subframe, Securing
Special tools and workshop equipment required
Torque Wrench 1331 5-50Nm -VAG1331-
Torque Wrench 1332 40-200Nm -VAG1332-
Engine and Gearbox Jack -VAS6931-
Gearbox Support -T40173-
Locating Pins -
Subframe, Lowering
Special tools and workshop equipment required
Torque Wrench 1331 5-50Nm -VAG1331-
Torque Wrench 1332 40-200Nm -VAG1332-
Tensioning Straps -T10038-
Engine and Gearbox Jack -VAS6931-
Locating Pins
SEE MORE:
Repairing a Wire 0.35 mm 2 or Greater with
Individual Crimp Connector
Procedure
- Free up the wire to be repaired approximately 20 cm on both
sides of the repair point.
Caution
Risk of damaging the electrical wires.
Expose wrapped wiring harnesses carefully.
- If necessary, removing the wiring harness wrapping using a
knife.
- Cut out the dam
Door Handle, Removing and Installing
Removing
- Remove the door handle trim. Refer to
→ Chapter "Door Handle Trim, Removing and Installing".
- Equipped on some models: Remove the exterior door handle
illumination bulb. Refer to
→ Electrical Equipment; Rep. Gr.94; Exterior Door Handle Lamps;
Exterio
© 2019-2026 Copyright www.audia4b9.com
