Audi A4: Suspension Strut and Upper Control Arm
Audi A4 (B9) 2016-2026 Service Manual / Chassis / Front Suspension / Suspension Strut and Upper Control Arm
- Overview - Suspension Strut and Upper Control Arm
- Suspension Strut, Removing and Installing
- Upper Control Arm, Removing and Installing
- Shock Absorber Fork, Removing and Installing
READ NEXT:
Overview - Suspension Strut and Upper Control Arm
Overview - Suspension Strut and Upper Control Arm
1 - Bolt
Replace after removing
2 - Control Arm
3 - Shock Absorber Fork
Removing and installing. Refer to
→&nbs
Suspension Strut, Removing and Installing
Torque Wrench 1331 5-50Nm -VAG1331-
Removing
- Remove the shock absorber fork. Refer to
→ Chapter "Shock Absorber Fork, Removing and Installing".
- Remove the tower brace. Refer t
Upper Control Arm, Removing and Installing
Special tools and workshop equipment required
Vehicle Diagnostic Tester
Torque Wrench 1331 5-50Nm -VAG1331-
Torque Wrench 1331 Insert - Ring Wrench - 16mm -VAG1331/12-,
not illustrated
Torque Wr
SEE MORE:
Repair a wiring 0.35 mm 2 or greater with
intermediate wire section
Note
For the repair use repair wires with a cross section of 0.35
mm2 through 6.0-mm2.
Procedure
- Free up the wire to be repaired at two places approximately
20 cm on both sides of the repair point.
Caution
Risk of damaging the electrical wires.
Expose wrapped wiring harness
Radiator/Radiator Fan
Overview - Radiator/Radiator Fan
1 - Radiator
Removing and installing. Refer to
→ Chapter "Radiator, Removing and Installing".
After replacing, replace entire amount of coolant
2 - Drain Plug
1.5 to 3 Nm
3 - O-ring
Replace after removing
4 -
© 2019-2026 Copyright www.audia4b9.com
