Audi A4: Steering Column
- Overview - Steering Column
- Steering Column, Checking for Damage
- Active Steering Safety Lock (Locking Solenoid), Removing and Installing
- Electronic Steering Column Lock Control Module -J764-, Removing and Installing
READ NEXT:
Overview - Steering Column
1 - Bolt
20 Nm + 90º
Replace after removing
Clean the threaded hole, for example, using a thread tap, before
installing the new bolt.
Install the bolt first by hand in the first thre
Steering Column, Checking for Damage
Visual Check
Components of the steering column must not show any
indications of damage.
Function Test
The steering column must turn without catching or difficulty
of movement.
The steering col
Active Steering Safety Lock (Locking Solenoid), Removing and Installing
Special tools and workshop equipment required
Vehicle Diagnostic Tester
Torque Wrench 1783 - 2-10Nm -VAG1783-
Removing
Note
To avoid a crooked steering wheel, the steering wheel must
no
SEE MORE:
Coolant Pump, Removing and Installing
Removing
- Remove the engine cover. Refer to
→ Servicing - 4-Cylinder 2.0L 4V TFSI Engine; Rep. Gr.10; Engine
Cover; Engine Cover, Removing and Installing.
- Drain the coolant. Refer to
→ Chapter "Coolant, Draining and Filling".
- Disconnect the connectors -
Footrest, Removing and Installing
Removing
- Pry off the cap -3- with a small
screwdriver.
- Remove the bolt -2- underneath.
- Pull the footrest -1- downward in
the direction of -arrow- and remove
it.
Installing
Install in reverse order of removal.
Installation instructions: For example tightening
specifications,
© 2019-2026 Copyright www.audia4b9.com
