Audi A4: Steering Gear
- Overview - Steering Gear
- Steering Gear, Removing and Installing
- Boot, Removing and Installing
- Tie Rod, Removing and Installing
- Steering Gear End Positions, Adapting
READ NEXT:
Overview - Steering Gear
Overview - Steering Gear
1 - Bolt
Replace after removing
Tightening specification -Item 2-
2 - Subframe Crossbrace
Overview. Refer to
→ Chapter "Overview - Subframe
Steering Gear, Removing and Installing
Special tools and workshop equipment required
Torque Wrench 1331 5-50Nm -VAG1331-
Torque Wrench 1332 40-200Nm -VAG1332-
Engine and Gearbox Jack -VAS6931-
Ball Joint Splitter -VAS251805-, not illu
Boot, Removing and Installing
Special tools and workshop equipment required
Torque Wrench 1331 5-50Nm -VAG1331-
Hose Clip Pliers -VAS6362-
Hose Clip Pliers -VAG1921-
Caution
This procedure contains mandatory replacea
SEE MORE:
Rear Bumper Cover, Removing and Installing
Special tools and workshop equipment
required
Body Socket -T40078-
Depending on the equipment version, the following additional work must be
performed.
Removing
- Remove the bolts -1-.
- Push the wheel housing liner -3- to
the side.
- Remove the bolt -2-.
- Remove the nut
Luggage compartment
lid
General information
WARNING
Applies to: vehicles with anti-theft alarm
system: When the vehicle is locked from the
outside, no one, especially children, should
remain in the vehicle, because the windows
can no longer open from the inside. Locked doors make it more difficult
for emergency work
© 2019-2026 Copyright www.audia4b9.com
