Audi A4: Repair Information
- Shock Absorber Leaks
- General Information
- Wheel Bearing in Curb Weight Position, Lifting Vehicles with Coil Spring
READ NEXT:
Shock Absorber Leaks
Vehicles with Coil Springs
Shock absorbers are frequently rejected and replaced because
of leaks. Examinations on the test stand and on the vehicle have
shown that the replacement of a large number
General Information
Caution
There is a risk of damaging the threads in the
vehicle body.
The bolts and nuts at all suspension parts must not
be loosened or tightened with an impact wrench.
Always install th
Wheel Bearing in Curb Weight Position, Lifting Vehicles with Coil Spring
Special tools and workshop equipment required
Engine and Gearbox Jack -VAS6931-
Tensioning Strap -T10038-
Engine/Gearbox Jack Adapter - Wheel Hub Support -T10149-
Note
All bolts on chassi
SEE MORE:
Door
Overview - Door
1 -
Door
Removing and installing. Refer to
→ Chapter "Door, Removing and Installing".
2 -
Bolt
8 Nm
Quantity: 2
3 -
Bolt
33 Nm
4 -
Cap
For the door arrester
Installation position. Refer to
→ Fig. "Cap Installation Pos
Power sources
When the ignition is switched on, you may be
able to use multiple power sources for external
devices, depending on the vehicle equipment.
12 volt sockets
You can connect electrical accessories to the 12
volt sockets. The power usage from the sockets
must not exceed a total of 120 watts. Do not
conne
© 2019-2026 Copyright www.audia4b9.com
