Audi A4: Lower Control Arm and Ball Joint
Audi A4 (B9) 2016-2026 Service Manual / Chassis / Front Suspension / Lower Control Arm and Ball Joint
- Overview - Lower Control Arm and Ball Joint
- Control Arm, Removing and Installing
- Guide Link, Removing and Installing
- Control Arm Ball Bearing, Replacing
- Ball Joint, Removing and Installing
READ NEXT:
Overview - Lower Control Arm and Ball Joint
1 - Wheel Bearing Housing Side Bonded Rubber Bushing
Replacing. Refer to
→ Chapter "Control Arm Ball Bearing, Replacing, Wheel Bearing Housing
Side".
2 - Bolt
Replac
Control Arm, Removing and Installing
Special tools and workshop equipment required
Spreader Tool -3424-
Torque Wrench 1332 40-200Nm -VAG1332-
Engine and Gearbox Jack -VAS6931-
Ball Joint Splitter -VAS251805-
Engine/Gearbox Jack Ada
Guide Link, Removing and Installing
Special tools and workshop equipment required
Torque Wrench 1332 40-200Nm -VAG1332-
Torque Wrench 1332 Insert - Ring Wrench - 21mm -VAG1332/7-
Engine and Gearbox Jack -VAS6931-
Puller - Ball Join
SEE MORE:
Current Draw Test
WARNING
Do not check or charge a Battery -A- when the visual
indicator has "no color or is
bright yellow". Jump starting must not be used!
There is a risk of explosion during testing,
charging or jump starting.
These Batteries -A- must be replaced.
Make sure the correct charging mode is
Overview - Suspension Strut, Shock Absorber, Spring
Overview - Spring
1 - Rear Lower Transverse Link
Removing and installing. Refer to
→ Chapter "Rear Lower Transverse Link, Removing and Installing".
2 - Coil Spring
Removing and installing. Refer to
→ Chapter "Spring, Removing and Installing".
Installation p
© 2019-2026 Copyright www.audia4b9.com
