Audi A4: Wheel Bearing
- Overview - Wheel Bearing
- Wheel Bearing Housing, Removing and Installing
- Wheel Bearing Unit, Removing and Installing
READ NEXT:
Overview - Wheel Bearing
1 - Wheel Bearing Housing
Removing and installing. Refer to
→ Chapter "Wheel Bearing Housing, Removing and Installing".
2 - Bolt
80 Nm + 90º
Replace after removing
Wheel Bearing Housing, Removing and Installing
Special tools and workshop equipment required
Spreader Tool -3424-
Torque Wrench 1332 40-200Nm -VAG1332-
Engine and Gearbox Jack -VAS6931-
Ball Joint Splitter -VAS251805-, not illustrated
Puller
Wheel Bearing Unit, Removing and Installing
Special tools and workshop equipment required
Torque Wrench 1332 40-200Nm -VAG1332-
Caution
This procedure contains mandatory replaceable parts.
Refer to component overview and parts cata
SEE MORE:
Refrigerant Circuit Pressures Specified Values, Vehicles with Heat Pump
Note
On vehicles with a high-voltage system and heat pump (for
example on the Audi Q7 e-tron) installed in the refrigerant
circuit and electrically activated vehicles which regulate the
flow of the refrigerant in the refrigerant circuit depending on
the current operating condition. The
Center Folding Backrest Trim Panel, Removing and Installing
Special tools and workshop equipment required
Pry Lever -80-200-
Removing
- Remove the center armrest. Refer to
→ Chapter "Center Armrest, Removing and Installing".
- Remove the cushion cover for the center folding backrest. Refer
to
→ Chapter "Center Folding Backrest C
© 2019-2026 Copyright www.audia4b9.com
