Audi A4: Drive Axle
- Overview - Drive Axle
- Drive Axle, Removing and Installing
- Drive Axle, Disassembling and Assembling
- CV Joint, Servicing
- Outer CV Joint, Checking
- Clamp on Triple Roller Joint and Outer Joint, Tensioning
READ NEXT:
Overview - Drive Axle
1 - Clamp
Replace after removing
Tensioning. Refer to
→ Chapter "Clamp on Triple Roller Joint and Outer Joint, Tensioning".
2 - CV Boot
If the drive axle has a peene
Drive Axle, Removing and Installing
Special tools and workshop equipment required
Torque Wrench 1332 40-200Nm -VAG1332-
Caution
This procedure contains mandatory replaceable parts.
Refer to component overview and parts cata
Drive Axle, Disassembling and Assembling
Drive Axle, Disassembling and Assembling, Triple Roller Joint AAR 2600 i
and AAR 3300 i
Special tools and workshop equipment required
Press Plate -VW401-
Press Plate -VW402-
Press Piece - Rod -VW
SEE MORE:
Manually releasing the parking lock
Fig. 98 Front cup holder: removing the cover
Fig. 99 Front cup holder: parking lock emergency release
The emergency release is located in the front cup
holder under a cover.
You will need the screwdriver and the socket
wrench from the vehicle tool kit in order to release. Use the flat side of the
Driver Front Airbag Crash Sensor -G283-, Removing and Installing
Note
The Passenger Side Front Airbag Crash Sensor -G284- is removed
and installed the same way.
Removing
WARNING
Risk of injury due to involuntary deployment.
Pay attention to the safety precautions when working
with pyrotechnic components. Refer to
→ Chapter "Safety Precau
© 2019-2026 Copyright www.audia4b9.com
