1 - Flywheel
Refer to the Parts Catalog because there are different versions
depending on the date of manufacture.
Removing an installing. Refer to
→ Chapter "Flywheel, Removing
Special tools and workshop equipment required
Puller - Clutch Module -T40176-
Clutch Disc Shaft Spline Lubricant -G 000 100-
Sealing Grease. Refer to the Parts Catalog.
Removing
Note
T
Removing
- Move the steering wheel as far to the rear and down as possible.
Use the full steering column adjustment range for this.
- Move the front seats all the way back and tilt backrests 45º.
WARNING
Risk of injury due to involuntary deployment.
Pay attention to the safety p
1 - Cap
Carefully drive off using a drift
Replace if damaged
Adhesive surface must be free of oil and grease
Coat the sealing surface with Sealant -D 454 300 A2- before installing on
CV joint.
2 - Circlip
Replace after removing
Insert in shaft groove
3 - In