Seat Belt Guide in Rear Seat Backrest, Removing and Installing
Special tools and workshop equipment required
Trim Removal Wedge -3409-
Removing
- Remove the center rear belt end fitting. Refer to
→ Chapter "Rear Seat Belt Latch, Removing and Installing".
- Release the catches -1-
1 - Bolt
20 Nm + 90º
Replace after removing
Clean the threaded hole, for example, using a thread tap, before
installing the new bolt.
Install the bolt first by hand in the first threads. Check if the
steering intermediate shaft is seated correctly by pulling. Then tighten
the bol