Audi A4: Rearview Camera System
- Overview - Rearview Camera System
- Rearview Camera -R189-, Removing and Installing
- Rearview Camera System, Calibrating
READ NEXT:
Overview - Rearview Camera System
The rear view camera system (KA2) assists the driver during
back-up driving for diagonal and parallel parking for trailer
towing and watching cross traffic by providing the driver with
an image of
Rearview Camera -R189-, Removing and Installing
Rearview Camera -R189-, Removing and Installing, Sedan
The Rearview Camera -R189- is inside the rear lid handle
button. It permanently attached to the handle button.
If the Rearview Camera -R189- mus
Rearview Camera System, Calibrating
Calibration Unit -VAS6350A-, Installing and Aligning
After performing repair work on the vehicle, it may be
necessary to re-calibrate the rearview camera system. In detail,
this is the case after:
SEE MORE:
Flywheel, Removing and Installing
Special tools and workshop equipment required
Puller - Clutch Module -T40176-
Clutch Disc Shaft Spline Lubricant -G 000 100-
Sealing Grease. Refer to the Parts Catalog.
Removing
Note
There is a normal "clicking" in
the dual mass flywheel with "LuK" centrifugal pendulum absorber
-A-.
Refrigerant Circuit, Charging with Service Station
Note
The entire refrigerant charge can be added to either the
high or low pressure side. Refer to
→ Chapter "Refrigerant R134a Capacities, Refrigerant Oil and
Approved Refrigerant Oils".
The work procedure is always to be performed as described in
the operating instructions for
© 2019-2026 Copyright www.audia4b9.com
