Audi A4 Owners & Service Manuals

Audi A4: Transmission Fluid Circuit

Overview - Transmission Fluid Circuit

Overview - Transmission Fluid Circuit

1 - Plug

  • 8 Nm +30º
  • Replace after removing.
  • For the ATF check and fill hole

2 - Plug

  • 35 Nm
  • Replace after removing.
  • For transmission fluid inspection and fill hole

3 - Transmission Fluid Pump (MTF Pump)

  • With seal welded on
  • Must be removed for draining the transmission fluid (MTF).
  • Replace the transmission fluid pump if the seal is damaged.
  • Removing and installing. Refer to → Rep. Gr.34; Transmission Fluid Circuit; Transmission Fluid Pump, Removing and Installing.

4 - Bolt

  • 3 Nm +90º
  • Replace after removing.

5 - Drain Plug

  • 35 Nm
  • Replace after removing.
  • For the ATF

Transmission Fluid Pump, Removing and Installing

Chapter: transmission fluid pump, removing and installing can be found in the repair manual "7-Speed Dual Clutch Transmission 0CK"

Refer to → Rep. Gr.34; Transmission Fluid Circuit; Transmission Fluid Pump, Removing and Installing.

ATF Circuit

All ATF circuit work can be found in the repair manual "7-Speed Dual Clutch Transmission 0CK"

Refer to → 7-Speed Dual Clutch Transmission 0CK; Rep. Gr.34; ATF Circuit.

Transmission Fluid

All transmission fluid work can be found in the repair manual "7-Speed Dual Clutch Transmission 0CK"

Refer to → 7-Speed Dual Clutch Transmission 0CK; Rep. Gr.34; Transmission Fluid.

ATF

All work for checking the ATF level and draining and filling can be found in the repair manual "7-Speed Dual Clutch Transmission 0CK".

Refer to → 7-Speed Dual Clutch Transmission 0CK; Rep. Gr.34; ATF; ATF Level, Checking.

Refer to → 7-Speed Dual Clutch Transmission 0CK; Rep. Gr.34; ATF; ATF, Draining and Filling.

    READ NEXT:

     DSG Transmission Mechatronic -J743-

    Overview - Mechatronic 1 - Transmission Fluid Pan Removing and installing. Refer to → Chapter "Transmission Fluid Pan, Removing and Installing". 2 - Bolt Tightenin

     Transmission Fluid Pan, Removing and Installing

    Special tools and workshop equipment required Engine Bung Set -VAS6122- Used Oil Collection and Extraction Unit -SMN372500- Removing   Note General repair instructions. Refer to → 

     Mechatronic, Removing and Installing

    Special tools and workshop equipment required Used Oil Collection and Extraction Unit -SMN372500- Assembly Tool -T40305- Oil Sump Assembly Pin -T40199- Electronic Torque Wrench 3-60Nm -VAS6583-

    SEE MORE:

     Voltage Regulator, Bosch Generator from 2001, Removing and Installing

    Removing - Remove the generator. Refer to → Electrical Equipment; Rep. Gr.27; Generator; Generator, Removing and Installing. - Remove the bolt -1- and the nuts -3- and -4-. - Remove the cover -2- on the rear side of the generator. - Remove the bolts -arrows

     Quick-Release Connections on Refrigerant Lines

      WARNING The quick-release coupling connectors may be unlocked and opened only if the refrigerant circuit is empty.   Note This illustration shows the quick-coupling connection with a refrigerant pipe with an inner heat exchanger that is installed in the Audi A4 from MY 2008 and

    © 2019-2026 Copyright www.audia4b9.com