Audi A4: Controls, Housing
- Transmission, Transporting
- Overview - Transmission
- Overview - Gear Set
- Transmission, Disassembling and Assembling
- Transmission Fluid Circuit
- DSG Transmission Mechatronic -J743-
- Transmission Fluid Pan, Removing and Installing
- Mechatronic, Removing and Installing
- Transmission Control Module -J217-, Removing and Installing
- Hydraulic Pressure Sensor 1 -G545- and Hydraulic Pressure Sensor 2 -G546-, Removing and Installing
- Special Tools
READ NEXT:
Transmission, Transporting
Special tools and workshop equipment required
Shop Crane -VAS6100-
Lifting Tackle -3033-
Hook And Support Tool -3311- with Hook And Support Tool -
Bolt -3311/1-
Retaining Strap -T40155-
Overview - Transmission
Overview - Transmission, FWD Vehicles
1 - Gear Set
Removing and installing. Refer to
→ Chapter "Overview - Gear Set, FWD Vehicles".
2 - Hydraulic Pressure Reservoir
O
Overview - Gear Set
Overview - Gear Set, FWD Vehicles
1 - Oil Pipe
2 - Bolt
3 Nm + 90º
Replacing
M6 × 30
3 - Gear Positioner with:
Transmission Input Speed Sensor 1 -G632-
Transmi
SEE MORE:
Seat Heating Element, Removing and Installing
Removing
- Separate the cover and cushion. Refer to
→ Chapter "Cover and Cushion, Separating, Bench Seat".
- Disconnect the wire -3- directly
from the old heating element -1-.
Note
The old heating elements remain on the cushion and will be
covered over by the new heating
Door Handle, Removing and Installing
Removing
- Remove the door handle trim. Refer to
→ Chapter "Door Handle Trim, Removing and Installing".
- Equipped on some models: Remove the exterior door handle
illumination bulb. Refer to
→ Electrical Equipment; Rep. Gr.94; Exterior Door Handle Lamps;
Exterio
© 2019-2026 Copyright www.audia4b9.com
