Underbody Trim Panel, Removing and Installing, Front
Removing
- Remove the nuts -arrows-.
- Remove the front underbody trim panel -2-
from the center underbody trim panel -1-.
Installing
Install in reverse order of removal.
Tightening Specifications
Refer to
→ Chapter "Overview
1 - Clamp
Replace after removing
Tensioning. Refer to
→ Chapter "Clamp on Triple Roller Joint and Outer Joint, Tensioning".
2 - CV Boot
If the drive axle has a peened triple roller joint, then the triple
roller joint has an adapter installed
The CV boot must fit