Audi A4: Hood, Lids
- Front Lid
- Front Lid, Removing and Installing
- Hinge, Resetting
- Release Cable, Removing and Installing
- Rear Lid
- Rear Lid, Removing and Installing
- Rear Lid, Adjusting
- Hinges, Removing and Installing
- Adjusting Buffer, Removing and Installing
- Gas-Filled Strut, Removing and Installing
- Rear Lid Closing Assist Motor -V382-, Removing and Installing
- Fuel Filler Door Unit
READ NEXT:
Front Lid
Overview - Front Lid
Overview - Hood
1 -
Adjusting Buffer
Adjusting. Refer to
→ Chapter "Height, Adjusting using Adjusting Buffer".
2 -
Striker
Removing and installin
Front Lid, Removing and Installing
To complete the procedure, a second technician is required to be at the
following position.
NOTICE
Risk of damaging the hood by opening when the pedestrian
protection is triggered.
-
Hinge, Resetting
To complete the procedure, a second technician is required to be at the
following position.
NOTICE
Risk of damaging the hood by opening when the pedestrian
protection is triggered.
-
SEE MORE:
Steering Gear End Positions, Adapting
Special tools and workshop equipment required
Vehicle Diagnostic Tester
Note
If the connection between the steering gear and the steering
wheel is disconnected, the end position of the steering gear
must be readapted.
Procedure
- Connect the Vehicle Diagnostic Tester.
- Switch
Additional Safety Precautions for Airbag Control Module
WARNING
After every removal and installation of the Airbag
Control Module -J234-, the "inertial sensor basic
setting" must be performed.
If the Airbag Control Module -J234- is replaced with a
new part, the basic setting is performed when
implementing the "15 - Replace airbag control
© 2019-2026 Copyright www.audia4b9.com
