Audi A4: Bumpers
- Front Bumper
- Front Bumper Cover, Removing and Installing
- Air Intake Grille, Removing and Installing
- Impact Member, Removing and Installing
- Attachments, Removing and Installing
- Rear Bumper
- Rear Bumper Cover, Removing and Installing
- Rear Bumper Cover Mount, Removing and Installing
READ NEXT:
Front Bumper
Overview - Bumper Cover
1 -
Towing Eye Cover
2 -
Bumper Cover
Removing and installing. Refer to
→ Chapter "Bumper Cover, Removing and Installing".
Adjusting. Refer to
Front Bumper Cover, Removing and Installing
To complete the procedure, a second technician is required to be at the
following position.
Special tools and workshop equipment
required
Pliers -T40172C-
Adapter -T40172/1-
Removing
- Push
Air Intake Grille, Removing and Installing
Air Intake Grille, Removing and Installing, Center
Removing
- Remove the front bumper cover end plate. Refer to
→ Chapter "Front Bumper Cover End Plate, Removing and
Installing".
- F
SEE MORE:
Front Peripheral Camera -R243-, Removing and Installing
The Front Peripheral Camera -R243- is installed in the
radiator grille under the Audi rings.
Removing
- Turn off the ignition and all electrical equipment and
remove the ignition key.
- Remove the front bumper cover. Refer to
→ Body Exterior; Rep. Gr.63; Front Bumper; B
Lock Carrier Trim Panel, Removing and Installing
Special tools and workshop equipment required
Omega Clip Tool -T40280-
Removing
- Remove the rear luggage compartment floor.
- Free up the lock carrier trim panel near the rear lid seal
-1-.
- Grip the trim panel -2- by hand and
carefully pull vertically upward -arrows-.
Installi
© 2019-2026 Copyright www.audia4b9.com
