Audi A4: Rear Doors
- Door
- Door, Removing and Installing
- Door Arrester, Removing and Installing
- Door Components
- Window Regulator, Removing and Installing
- Door Handle, Removing and Installing
- Door Lock Cable, Removing and Installing
- Window Guide, Removing and Installing
READ NEXT:
Door
Overview - Door
1 -
Door
Removing and installing. Refer to
→ Chapter "Door, Removing and Installing".
2 -
Bolt
33 Nm
3 -
Door Arrester
Removing and insta
Door, Removing and Installing
Removing
- Disconnect the door cut-off connector -1-
at the B-pillar. Refer to
→ Electrical Equipment; Rep. Gr.97; Connectors.
- Tape off the B-pillar in the door arrester
Door Arrester, Removing and Installing
Removing
- Tape off the B-pillar in the door arrester area using adhesive
tape, so that the paint will not be damaged.
- Move the door window into the "closed" position.
- Remove the r
SEE MORE:
Vehicles with Coil Springs, Checking the Curb Weight Position for Axle
Alignment
The curb weight position must be checked before beginning an
axle alignment on vehicles with coil springs. Explanation of the
curb weight position.
Determine the Dimension -a-
- Determine dimension -a- between
the center of the wheel and the lower edge of the fender/wheel
housing as shown.
Shock Absorber Leaks
Vehicles with Coil Springs
Shock absorbers are frequently rejected and replaced because
of leaks. Examinations on the test stand and on the vehicle have
shown that the replacement of a large number of rejected shock
absorbers was not justified.
Slight leaking of oil ("sweating") at piston rod sea
© 2019-2026 Copyright www.audia4b9.com
