Audi A4: Body Front
- Lock Carrier
- Bumper Cover Bracket, Removing and Installing
- Fender
- Fender, Removing and Installing
- Fender Brace, Removing and Installing
- Fender Front Cover, Removing and Installing
- Bulkhead
- Plenum Chamber Bulkhead, Removing and Installing
READ NEXT:
Lock Carrier
Overview - Lock Carrier
1 - Impact Member
2 - Air Duct
Clipped into the bumper cover bracket
3 - Bolt
8 Nm
4 - Lower Air Guide
For the radiator
5 -&
Bumper Cover Bracket, Removing and Installing
Follow the safety precautions. Refer to
→ Body Interior; Rep. Gr.00; Safety Precautions; Safety
Precautions when Working on Pyrotechnic Components.
Removing
- Remove the impa
Fender
Overview - Fender
1 -
Nut
8 Nm
2 -
Outer Fender Brace
Removing and installing. Refer to
→ Chapter "Brace and Outer Fender Brace, Removing and Installing".
3 -&n
SEE MORE:
Input Shaft Double Shaft Seal, Replacing
Special tools and workshop equipment required
Puller - Crankshaft/Power Steering Seal -T20143-
Thrust Piece -T40300-
Clutch, engaging bearing and slave cylinder removed. Refer
to
→ Chapter "Dual Clutch, Removing and Installing".
- With the Puller - Crankshaft/Power Steering Seal
Predictive control
Applies to: vehicles with Audi adaptive cruise control and efficiency
assist
With predictive control, efficiency assist adapts
the set speed in adaptive cruise control (1), fig. 108 based on detected speed
limits and the upcoming route. Once the system
no longer detects any incidents ahead, adaptive
© 2019-2026 Copyright www.audia4b9.com
