Audi A4: Cooling System
- Coolant System/Coolant
- Coolant Pump/Coolant Thermostat
- Electric Coolant Pump, Removing and Installing
- Coolant Pump, Removing and Installing
- Radiator/Radiator Fan
- Radiator, Removing and Installing
- Fan Shroud, Removing and Installing
READ NEXT:
Coolant System/Coolant
Connection Diagram - Coolant Hoses
Connection Diagram - Coolant Hoses, Versions without Parking Heater
Note
Blue = large coolant circuit.
Red = small coolant circuit.
Brown = heating circu
Coolant Pump/Coolant Thermostat
Overview - Coolant Pump/Coolant Thermostat
1 - Connection
2 - O-ring
Installation instructions. Refer to
→ Servicing - 4-Cylinder 2.0L 4V TFSI Engine; Rep. Gr.19;&n
Electric Coolant Pump, Removing and Installing
Coolant Recirculation Pump -V50-, Removing and Installing
Special tools and workshop equipment required
Hose Clamps - Up To 25mm -3094-
Hose Clip Pliers -VAS6340-
Removing
- Remove the engine
SEE MORE:
Brake fluid
Fig. 161 Motor compartment: cap on brake fluid reservoir
Observe the safety precautions General
information.
Checking the brake fluid level
The brake fluid reservoir is located under a cover
on the driver's side.
Park the vehicle on a level surface.
Lift the cover fig. 158 at both
openings and
Mounting Bracket, Removing and Installing
NOTICE
Risk of damaging the operating cable by deforming it.
- Never sharply bend or kink the operating cable.
Removing
- Move the door window into the "closed" position.
- Remove the door handle. Refer to
→ Chapter "Door Handle, Removing and Installing".
- Driver
© 2019-2026 Copyright www.audia4b9.com
